ANARCHY 9g

A dual-wielding jig that can handle both points and lines at a high level.

Original design high strength hook with "rear barb"

The rear barb is a specification where the barb is positioned further back than the conventional barb position. The barb is located at the position where the needle tip penetrates, so it achieves efficient hooking up even with small power. In addition, the surface treatment using the resin "PTFE" with excellent low friction properties has achieved excellent piercing.

Approach angle with minimal power loss

The approach angle is set at 20° to minimize power loss, allowing hooking up power to be transmitted efficiently to the tip of the hook for a sure hooking up set.

Line Eye

The head shape is designed so that the knot does not move forward. The head touches the obstacle before the line, reducing snagged and damage to the line. In addition, the knot does not move from the ideal position when jigging, so it is possible to produce a stable action.

Distinctive head design

The head shape with sharp edges on both sides prevents the lure from tipping over when it comes into contact with an obstacle, reducing the risk of it getting caught on roots.

Models using POWER FLARE -Power Flare Rubber-

Uses a power flare rubber with strong water displacement. When it falls, each rubber vibrates finely, inviting bite. In addition, because it has a large water resistance, it allows for a pin-spot approach with a short travel distance. It is also effective to cut the rubber to change its vibration and resistance.
*Power Flare is delivered in a special three-dimensional package.

Standard Rubber Model

The 5g and 7g models use 0.4mm thick silicone rubber, while the 9g, 11g, and 14g models use 0.5mm thick silicone rubber.
The number of pieces is changed for each weight and optimized.

Power flare rubber model

All weights use 1.0mm thick rubber with a strong flare feel.

Brush guard

The oval guard is designed to protect the tip of the bait and ensure that it will penetrate if there is bite. The length and number of brushes are set for each weight. If the guard is too strong, it is effective to cut it and adjust the number.
*When adjusting the number of pieces, be sure to cut them rather than pull them out.

softbait keeper

In addition to the keeper made of the same material as the head, a wire keeper is also used. The wire keeper is placed on the inside so as not to interfere when hooking up or slipping through cover.

5g/7g・9g/11g・14g フックサイズ

5g: Use hook size 1 (tensile test strength: approx. 9.0kgf)
7g and 9g: Use hook size 2/0 (tensile test strength: approx. 10.0kgf)
11g and 14g: Use hook size 3/0 (tensile test strength: approx. 12.0kgf)

PTFE Armor

The original high-strength hook is surface-treated with the low-friction resin "PTFE" to provide outstanding piercing performance.

Power Flare Rubber Caution

Due to the characteristics of the material, the rubber may become cloudy depending on the storage conditions, but this is not a defect or deterioration.
It can be removed by soaking it in water.